3D Tap Code

On the Subject of 3D Tap Code

WARNING! only works on ruleseed 1

Hold the module to hear a series of clicks. Each triplet of clicks encodes a letter as shown in the letter cube on the right. Determine in which order the coordinates are transmitted. Only one coordinate order results in a word contained in the word cube below. The lookup table(s) on the next page give you the encoding of each letter for each coordinate order, where X is horizontal movement (i.e. A to B to C), Y is vertical movement (i.e. A to D to G), and Z is depth (i.e. A to J to R).

Within the word cube, start from the decoded word, and move A spaces along the first coordinate, B along the second and C along the third (wrapping around the edges), where A, B, C are the first three characters of the serial number (A = 1, ..., Z = 26).

Transmit the new word using the same coordinate system to disarm the module. Tap the module 1 to 3 times for each coordinate, then wait for a click sound before proceeding to the next coordinate. Holding the module will reset your input.

1									2									3
1			2			3			1			2			3			1			2			3
1	2	3	1	2	3	1	2	3	1	2	3	1	2	3	1	2	3	1	2	3	1	2	3	1	2	3
XYZ Order
A	J	R	D	M	U	G	O	X	B	K	S	E	-	V	H	P	Y	C	L	T	F	N	W	I	Q	Z
XZY Order
A	D	G	J	M	O	R	U	X	B	E	H	K	-	P	S	V	Y	C	F	I	L	N	Q	T	W	Z
YXZ Order
A	J	R	B	K	S	C	L	T	D	M	U	E	-	V	F	N	W	G	O	X	H	P	Y	I	Q	Z
YZX Order
A	B	C	J	K	L	R	S	T	D	E	F	M	-	N	U	V	W	G	H	I	O	P	Q	X	Y	Z
ZXY Order
A	D	G	B	E	H	C	F	I	J	M	O	K	-	P	L	N	Q	R	U	X	S	V	Y	T	W	Z
ZYX Order
A	B	C	D	E	F	G	H	I	J	K	L	M	-	N	O	P	Q	R	S	T	U	V	W	X	Y	Z

On the Subject of 3D Tap Code

The Lookup Table