On the Subject of Soloing Binary LEDs

I'm not afraid of the RED wire, it's just that we don't need to cut it.

Check the entire flashing sequence to see which codes (shown above, referred to as keys) are present, then take the ones that are present and combine their corresponding colors additively to get both which wire to cut and when.

W	K
C	R
M	G
B	Y

• Cut GREEN when Grayscale. otherwise cut BLUE.
• Note that the pairs below are opposites.
  • 12 and start or end ⇒ 123 125
  • CaR 23
  • MuG last 4 or 1 ⇒ 2345 5
  • BuY 1 T-O or T-W-O 5 ⇒ 12345 125