On the Subject of The Block

It’s a Cube! Oh no, it’s a Block. At least this one doesn’t move!

  • To defuse, press the correct side(s) of the Block.
  • Each side of the Block is represented by the buttons on the module, relative to the net below.
  • The Block itself is also a button. If the module asks to press “side x”, press the button relative to that location on the net.
  • PLEASE NOTE: Button presses reset on a strike, and the colours WILL change.
  • See the image below for the orientation of the Block. This does not change.

To Disarm:

  • Bob loves the Block. If his indicator is lit, there are 3 batteries in 2 holders, & an empty port plate, press the Block 5 times.
  • Otherwise, if parallel > 0, serial port > 0, & side 4 = green, press the first green side in the net.
  • Otherwise, if the serial contains a vowel & there is an unlit SIG indicator, press all sides in reverse numerical order.
  • Otherwise, if batteries > 2 & side 1 = red, press side 5.
  • Otherwise, if blue sides > red sides & yellow sides > green sides, press side 2, then side 4.
  • Otherwise, if yellow sides = 0, press all sides in numerical order.
  • Otherwise, if side 2 = yellow & side 3 = blue, press on the Block.
  • Otherwise, if lit indicators = 0, side 2 = blue, and side 4 = blue, press the last blue side in the net.
  • Otherwise, if port plates = 2 & empty port plate > 0, press all even sides in numerical order.
  • Otherwise, if side 5 = blue & side 1 = green, press all odd sides in reverse numerical order.
  • Otherwise, if batteries = 0 & side 3 = blue, press the first blue side in the net.
  • Otherwise, if DVI-D ports > 0 & batteries = 1, press on the Block.
  • Otherwise, if red sides > blue sides, press side 1, then side 4.
  • Otherwise, press side 4.